This is merely a visual comparison showing the similarity of the two samples. The most salient point is that the ORME/MFKZT has gone to a metallic state from exposure to Sunlight!

Elixir base ‘white-gold’ aka ORMs sundried for 4 hours in AZ sun. This material was snow white before getting a sun bake. Some of the flakes have turned black metallic.

It has been said by the Essene and others that leaving ‘white-gold’ in the sun for a year will stabilize the PGMs to metallic. You would need miles of greenhouses to keep it from blowing around though.

Oct 24, 2012 ORMUS/ORME converion to Metallic PolySulfide

PGM salts on selective resin loaded and dried @ 400F

PGM salts have this classic orange color. 
Unfortunately the resin did not stabilize the PGMs as metallic and the project has been abandoned.  Cost about $500K.

The starting amount of Elixir base here is roughly the equivalent of 1/2 of 4 oz bottle of ZENergy.

Nutritionals Order Page

Object: of the experiment was to convert 100ml of Cosmetic Grade ORME to Metallic atomic cluster size demonstrating that the Amorphous Colloidal Silica does contain elements whose clusters are below the threshold for Metallic behavior.

Procedure: 100 ml snow white filtered ORME was taken to a pH of -0.5 with the addition of 30% HCl and constant stirring.
Heat was applied with constant stirring for 1.5 hrs at 100C. Allowed to cool to 50C then a 20% solution of NaOH was added to bring pH to 10.8 (mixture is now slightly gray in appearance).
30% HCl was added again taking the pH to 0
20% NaOH added bringing pH to 2.5, then addition of NaBH4 slowly bringing pH to 7.0 (mixture is deeper gray in appearance).
2 ml of TR-6 PolySulfide added under constant stirring. Mixture is then vacuum filtered through 7 micron glass filter media to remove water.
Photos were then taken of the finished product and shown below:

Shown above is the hydrated Silica containing ORME/MFKZT, that has been preciptitated at pH10.8

Shown above is 100 ml of the starting material shown to the left here after the Procedure described above. The gray color is due to the sub-metallic PGE clusters (aka ORME) having now clustered up to metallic state and then further aggregated as polysulfides.

My associates and I spent many years in R&D on this specific Prima Materia and were able to consistently prove via Fire Assay, conversions to levels of Au +/- 100 TO/T, Rh+/_50 TO/T, Ir +/- 150 TO/T, Pt +/- 75 TO/T. There were no Base or Toxic Metals detected in the starting material and none showing following the conversions.

Nutritionals Order Page


Oct 25, 2012 I ran a variation of the experiment above by preciptitating ORMUS from 25gm Celtic Sea Salt using KOH to a pH of 10.8 Then added 2 drops TR6 and vacuum filtered on glass 5 micron media. The result is show below. There are no visible metal polysulfides.

I then added 30% HCl to a pH of 2.0 then reduced with NaBH4 to a pH of 8.5 Still nothing visible.
I then added HCl to a pH of 5.0 added 2 drops TR6 then raised pH to 7.5 At this point there was some ‘floc visible. The mixture was taken to pH 2.0 with HCl then vacuum filtered onto the glass media. The result shown below.

Filter media diameter is 2”

The following series of pics is setup for 3 gm MSM dissolved in 40 ml R/O water with 40 ml MFKZT added. Beaker was then set on top of WiFi router which is sitting on top of DSL. Cell phone was propped against the beaker and called every 30 min. The purpose of the experiment is to visually see if  MSM and/or EMFs will convert the ‘ORME’ in MFKZT to a metallic state.

The images below were taken after 24 hrs on the WiFi, DSL, cellphone setup.

No treatment

pH taken to <2 with HCl, 4 drops TR6, then H Reduction to pH 8.6, in sunlight. Total time 20 min.

Please note Purple tint (Au) to the nano-colloidal suspension.

Stone of Heaven v6.0 ORME glass

Stone of Heaven v6.0 ORME glass
metallic high Rh/Ir with Pt, Pd, Au

The above pic is indicative of the amount of m-PGEs in the average Stone of Heaven 30 gm. XRF indicates Ir, Rh, Pd, Pt, Au, Ag.

“Seeing is Believing”

The image above is example of the Silica strand web structure. The transparent beads on the web are the PGEs in non-metallic form. For more microscopy Click Here

The image above is of the nano beads on the Silica that have been reduced to metallic and undergone fire assay. The metals have been identified by XRF as mainly Pd and Rh with Au, Pt, Ir.

     As you can plainly see in the above pics, the Platinum Group Elements (M-5) are not chemically bound in any manner to the Silica but rather merely stuck on like flies stuck on a spiderweb.
Since there is no chemical bonding of the PGEs, they are freely available to catalyze organic reactions. Your body is an organic engine. Imagine what could happen as you up the performance of that engine.

Image shown below is demonstrating the green mono Gold in a fusion state with the Silica. This material will then be solubilized and filtered. The resulting filtrate will undergo a reducing precipitation and yield the basis for the product line.

Nutritionals Order Page